• The ESC has an onboard filter capacitor that suppresses the back electromotive force, stabilizes the battery voltage, and protects the flight control ESC precision components.
• Built-in inverter, which can actually be installed in any spare UART.
• EMI Shell provides a stronger anti-interference capability.
• DJI FPV OSD is supported by any spare UART
• VTX 10V/Vbat filtered power ON/OFF switch
• Flight control onboard voltage sensor
• F722 HD Pro 3 Flight Controller
• 30x30 Mounting Pattern
• KM60 60A 128K ESC
• 3-6S LiPo Support

Specifications

SkyStarsRC F7HD Pro3 FC

• MCU: STM32F722RGT6 216MHz
• Gyroscope: BMI270
• Baro: Bmp280
• OSD: Betaflight SPI OSD DJI HD OSD(UART6)
• Black box: 16MB
• 6x Uarts: UART 1/2/3/4/5/6
• 4x PWM outputs
• 1x I2C
• 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red)
• USB Type-C(USB2.0)
• 1x JST-SH1.0_8pin connector (Gnd/Vbat/S1/S2/S3/S4/Rx3/Curr)
• 1x JST-SH1.0_6pin connector (R1/G/R6/T6/G/10V)
• VTX 10V/Vbat filtered power ON/OFF switch
• DJI FPV OSD is supported by any spare UART
• LED: 4 LED independent pads, support WS2812 programming lamp output. Receiver: Support Sbus, CRSF, IBUS, SBUS, XBUS, support 3.3v Spektrum satellite receiver, The default receiver input is UART1(You can solder ELRS RX on UART1), F7 has a built-in inverter, which can actually be installed in any spare UART.

KM60 60A 4in1 ESC

• Input voltage: 3-6S LiPo
• Con. Current: 60A
• Peak Current: 70A≥ 10S
• Firmware: BLHeli_32
• Support: Dshot 600/1200
• Mounting pattern: 30.5mm/M3
• BEC: No
• Product size: 41x46x7.6mm
• Weight: 17g about

Includes

• 1x SkyStarsRC Fly Stack F7 HD Pro3 3-6S 30x30 Stack/Combo (F722 FC / KM60 32Bit 60A 4in1 ESC)
• 4x Damping Rubbers (M3x3.5mm)
• 1x XT60 connector and wires
• 2x 8pin wiring harness (1x 70mm,1x 50mm)
• 1x 35v 560uf Capacitor