NewBeeDrone BeeBrain BLV4 AIO Flight Controller ExpressLRS (ELRS) 2.4G

Warning! 
The BeeBrainBLV4 OSD might not compatible with third party camera. If you are planning to use it for customized build, Please be aware it only support the camera below: 

How to Video:
Internal ELRS Rx Firmware flashing:

NewBeeDrone BeeEye Camera
Runcam Nano4 

Specifications

• STM32F411 MCU
• ESC Firmware: S-H-40 - Bluejay, 0.16, 48kHz.
• ESC Specifications: 4 channel 12A ESC
  
• ESC Connector: JST-1.0 3Pin
• NBD OSD (Betaflight OSD Compatible)
• Weight: 6.5 grams (including antennas and battery connector)
• Size: Outer dimensions 29 x 29 x 7.6 mm
• Holes: 25.5 x 25.5 mm
• Battery input: 1S
• Connector: PH2.0
• UART2 TX and RX for onboard EXPRESSLRS receiver (SX1280)
• UART1 TX and RX free
• VTX Adjustble power: 5mW-25mW-SmartMAX. SmartMAX will automatically adjust the VTX power according to the board temperature. When the board temperature rises, the VTX power will be automatically reduced. When the temperature is low, the maximum output power can be up to 400mW

Includes

• 1 x BeeBrain BLV4 Flight Controller
• 4 x Grommet
• 4 x Screw
• 1 x Receiver T-Antennas 
• 1 x Receiver Antennas
• 1 x VTX Antenna
  
  

Firmware: 
1. ELRS Receiver firmware can be found here. Vendor choose NewBeeDrone
2. BeeBrain blv4 ELRS Betaflight 4.4 firmware

All new firmware can be found on our Github Page

Note: Binding process. power up the drone 3 times, on the third time you plug in power, the ELRS Receiver will get into binding mode. We are still trying to work on the ELRS firmware and make it able to just click the boot button to get into bind mode. Will get this update in the near future. 
Check out the video below CiottiFPV show you how to get into bind mode. - Thanks bro for showing this. lol