The Kakute F4 V2.4 is ready for DJI HD. Easily plug in and power your HD video transmitter (like DJI O3 Air Unit & Caddx Vista) with its on-board 9V/A regulator, plus 5 dedicated UARTs w/inversion for peripherals. This stack comes with a barometer, plus LED/buzzer pad & I2C for external GPS/Magnetometers. The Tekko32 is the first 4in1 ESC, featuring the powerful F4 MCU @150Mhz, giving you smooth control & fast response, 4~6S & BLHeli32 for 30x30 stack/combo. 

Check out all our 30x30 Stacks and the rest of our HolyBro selection!

Features

• New and faster F4 MCU @ 150Mhz (compared to F3 @108Mhz & F0 @48Mhz)
• PWM Frequency: 16k to 96k
• Separate drive & control circuit, this broadens the current capability of the drive circuit while reducing the electrical interference to the control circuit.

 Specifications

Holybro Kakute F4 HD V2.4 2-8S 30x30 Flight Controller

• MCU: STM32F405
  
• IMU:  MPU6000
  
• Barometer: BMP280
  
• OSD: AT7456E
  
• 5x UARTs (1,3,4,4,6,7)
  
• 128 Mbit Dataflash chip
  
• Battery input voltage: 2-8S
  
• BEC 9V/3A - Optimized for DJI O3 Air unit
  
• BEC 5V/2A
  
• 7x PWM Outputs (6 Motor Output, 1 LED)
  
• Supports serial receivers (SBUS, iBus, Spektrum, Crossfire, ESLR).
  
• Mounting: 30 x 30mm, Φ4mm hole with M3 Grommets
  
• Dimension: 37x37mm
  
• Weight: 7g
  
• JST-SH1.0_8pin port (For 4in1 ESCs)
  
• JST-SH1.0_6pin port (For DJI/Caddx HD System and other VTX)

Tekko32 F4 4in1 50A ESC

• Continuous Current: 50A x4
• Burst Current: 60A x4
• Supports 4-6S battery
• Supports DShot 150/300/600/1200 & MultiShot/OneShot/Proshot/PWM etc.
• ESC telemetry Supported
• Onboard analog current sensor
• No output BEC
• BLHeli_32 firmware
• 1000uf 35v capacitor included (highly recommended for 6s setup)
• Amperage meter scale ratio: 120 (V1.9 Version)
• Dimensions: 48x37x6mm / Weight: 13.8g
• Mounting holes: M4 30.5x30.5mm (M3 grommets included)

Includes

• 1x Holybro Kakute F4 HD V2.4 4-6S 30x30 Stack/Combo (F405 FC/ 50A F4 32bit 4in1 ESC)
• 1x Wiring Kit

Wiring Diagram